Products

About Us

Knowledge Center

Accessories

Terms of Use

Featured Products

Site Map

Videos

Contact Us

Motorized Single-axis Table

Home > Motorized Linear Actuators > Low Cost Linear Single-axis Stages

Stepper Motor Driven Linear Single-axis Stage, Travel  : 50 mm, Stage Size: 90 by 90 mm

This motorized positioning table is made of aluminum alloy with an elegant black anodized surface.

It provides 50 mm of travel at a Maximum Speed with Stepper Motor of 40 mm per second. The drive mechanism is lead screw.

The bench size is 90 X 90 mm and has a body weight of 2.8 Kg.

The maximum load of this stage table is 15 Kg.

The resolution of 2 microns is achieved with a 10 micro-steps per step stepper motor driver. This linear stage is
also available with a Three Phase Brushless Servo Motor and Optical Encoder (-02 Version)

The knob mounted on the motor allows for manual adjustment. This knob may be replaced with an Optical Encoder (-04 Version) for precision position verification.

This stage requires a Motion Controller that can be ordered as a complete plug-and-play system with RS-232, USB, joystick, trackball, and keypad control.

Specifications
Type

AQ120-50

Structure Description

Travel

50 mm

Stage Size 9090 mm
Lead Screw Pitch 4 mm per turn
Travel Guide

High Precision Linear Ball Bearing

Two-Phase Stepper Motor (1.8)
Typical Phase Resistance 3.8 Ohms,  Bi-directional
Typical Phase Current 1 Amp
DB-9 Male Connector
Pin Assignment and Description

1

+5 VDC

2

Near Motor Limit Switch Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor

3

Far End Limit Switch Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor

4

Common

5

Not Connected

6 Stepper Motor Phase A+
7 Stepper Motor Phase A-
8 Stepper Motor Phase B+
9 Stepper Motor Phase B-

 

Body Material Aluminum Alloy
Surface Treatment Black Anodized
Load capacity 15 kg
Weight 2.8 kg

Typical Accuracy

Resolution Control Electronics Dependent, 2 microns with 10 Micro-steps per Step Motor Driver in use
1 micron with 10 Micro-steps per Step Motor Driver in use
Maximum Speed with Stepper Motor 25 mm/sec
Maximum Speed with Servo Motor  
Positioning Accuracy 10 microns

Accessories Description

Optical Encoder (-04 Version)
Three Phase Brushless Servo Motor and Optical Encoder (-02 Version)


Mechanical Drawing

Click to Get the STEP file

 Ordering Information

Part No. Description Amount
AQ120-50-01 Stepper Motor Driven Linear Single-axis Stage, Travel  : 50 mm Click to Get a Quote
AQ120-50-02 Three Phase Brushless Servo Motor with Quadrature Incremental Optical Encoder Driven Linear Single-axis Stage, Travel  : 50 mm Click to Get a Quote

Motion Controllers
Sharing link:


 

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us