Products

About Us

Knowledge Center

Accessories

Terms of Use

Featured Products

Site Map

Videos

Contact Us

Motorized Single-axis Table

Home > Motorized Linear Actuators > Low Cost Linear Single-axis Stages

Stepper Motor Driven Linear Single-axis Stage, Travel: 700 mm, Table Size 150 mm by 150 mm

This motorized positioning table is made of aluminum alloy with an elegant black anodized surface.

It provides 700 mm of travel at a Maximum Speed with Stepper Motor of 40 mm per second. The drive mechanism is lead screw.

The bench size is 150 X 150 mm and has a body weight of 8.3 Kg.

The maximum load of this stage table is 50 Kg.

The resolution of 2 microns is achieved with a 10 micro-steps per step stepper motor driver. This linear stage is
also available with a Three Phase Brushless Servo Motor and Optical Encoder (-02 Version)

The knob mounted on the motor allows for manual adjustment. This knob may be replaced with an Optical Encoder (-04 Version) for precision position verification.

This stage requires a Motion Controller that can be ordered as a complete plug-and-play system with RS-232, USB, joystick, trackball, and keypad control.

 

Specifications
Type

AQ150-700H

Structure Description

Travel

700 mm

Stage Size 150150 mm
Lead Screw Pitch 5 mm per turn
Travel Guide

High Precision Linear Slide Guide

Two-Phase Stepper Motor (1.8)
Typical Phase Resistance 3.8 Ohms,  Bi-directional
Typical Phase Current 1 Amp
DB-9 Male Connector
Pin Assignment and Description

1

+5 VDC

2

Near Motor Limit Switch Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor

3

Far End Limit Switch Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor

4

Common

5

Not Connected

6 Stepper Motor Phase A+
7 Stepper Motor Phase A-
8 Stepper Motor Phase B+
9 Stepper Motor Phase B-

 

Body Material Aluminum Alloy
Surface Treatment Black Anodized
Load Capacity 50 kg
Weight 8.3 kg

Typical Accuracy

Resolution Control Electronics Dependent, 2.5 microns with 10 Micro-steps per Step Motor Driver in use
1.25 microns with 20 Micro-steps per Step Motor Driver in use
Maximum Speed with Stepper Motor 40 mm/sec
Maximum Speed with Servo Motor  
Positioning Accuracy 10 microns

Accessories Description

Optical Encoder (-04 Version)
Three Phase Brushless Servo Motor and Optical Encoder (-02 Version)


Mechanical Drawing

Click to Get the STEP file

 Ordering Information

Part No. Description Amount
AQ150-700H-01 Stepper Motor Driven Linear Single-axis Stage, Travel  : 700 mm Click to Get a Quote
AQ150-700H-02 Three Phase Brushless Servo Motor with Quadrature Incremental Optical Encoder Driven Linear Single-axis Stage, Travel  : 700 mm Click to Get a Quote

 

Motion Controllers
Sharing link:


 

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us