Products

About Us

Knowledge Center

Accessories

Terms of Use

Featured Products

Site Map

Videos

Contact Us

Motorized XYZ-axis Linear Positioning Stages

Home > Assorted Motorized Multi-axis Actuators

This motorized positioning table is made of aluminum alloy with an elegant black anodized surface.

The drive mechanism is high precision crossed roller.

The knob mounted on the motors allow for manual adjustment. These knobs may be replaced with an optical encoders for precision position verification.

This stage is compatible with OES' line of
Motion Controllers..

Specifications

Structure Description

Travel
Range of Travel (mm) Pitch of Lead Screw Resolution
15 1 mm per turn 0.5 μ (10 Micro-steps per Step Motor Driver in use)
30 1 mm per turn 0.5 μ (10 Micro-steps per Step Motor Driver in use)
50 1 mm per turn 0.5 μ (10 Micro-steps per Step Motor Driver in use)
75 1 mm per turn 0.5 μ (10 Micro-steps per Step Motor Driver in use)
100 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
150 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
200 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
300 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
400 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
500 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
600 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
700 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
800 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
900 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
1000 4 mm per turn 2 μ (10 Micro-steps per Step Motor Driver in use)
Travel Guide

High Precision Crossed Roller

Motor
 
Phase Resistance 3.8 Ohm, Bi-directional
Typical Phase Current 1 Amp
DB-9 Male Connector
Pin Assignment and Description
1 +5 VDC for the Limit Sensors
2 Positive Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor (1000 OHM)
3 Negative Limit Switch, Open Collector, Normally Open, Needs Pull up Resistor (1000 OHM)
4 Return for+5 VDC
5 Not Connected
6 Motor Phase A+
7 Motor Phase A-
8 Motor Phase B+
9 Motor Phase B-
Body Material Aluminum Alloy
Surface Treatment Black Anodized

Typical Accuracy

Maximum Speed 5 mm / sec
Repeatability 10 μ
Positional Accuracy 10 μ

Accessories Description

Optional Optical Encoders
Optional Servo Motors
Other Sizes and Strokes Available

Ordering Information

Part No. Description Amount
XYZ-xxxx-yyyy-zzz-vv Motorized Three-axis XYZ-axis Stage

xxxx denotes the stroke of the X-axis in mm.
yyyy denotes the stroke of the Y-axis in mm.
zzz denotes the stroke of the Z-axis in mm.
vv denotes the version.

Click to Get a Quote

 

 

Sharing link:


 

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us