Products

About Us

Knowledge Center

Accessories

Terms of Use

Featured Products

Site Map

Videos

Contact Us

Hollow Cure Motorized Rotary Stage

Home > Motorized Rotary Stages

Hollow Core Motorized Horizontal Rotary Stage, Stage Diameter: 3.937 in (100 mm) 

This motorized rotary stage is made of aluminum alloy with an elegant black anodized surface.

The drive mechanism is worm and worm gear. The worm gear ratio is 180:1.

It provides 360 degrees  of continuous rotation.

The maximum load of this rotary table is 45 Kg.

This 100 mm diameter rotary actuator has a body weight of 1.7 Kg.

The resolution of +/-0.01 degrees   is achieved with a 10 micro-steps per step stepper motor driver. This rotation stage is also available with a servo motor and optical encoder.

The top plate mounted indicator shows the angle of rotation.

The knob mounted on the motor allows for manual adjustment. This knob may be replaced with an optical encoder for precision position verification.

This motorized stage is capable of continuous spinning.

This stage requires a Motion Controller that can be ordered as a complete plug-and-play system with RS-232, USB, joystick, trackball, and keypad control.

 

Specifications
Type

AY110-100

Structure Description

Range of Travel

360 degrees

Stage Diameter 100 mm
Through Hole Diameter 30 mm
Gear Ratio 180:1
Drive Mechanism

Worm Gear

Travel Guide Bearing
Stepper Motor

 Number of Steps per Revolution 200
Typical Phase Resistance 3.8 Ohms, Bi-directional
Typical Phase Current 1 Amp
DB-9 Male Connector
Pin Assignment and Description

1

+5 VDC for HOME Switch

2

Not Connected

3

Not Connected

4

Common

5

HOME Switch, Open Collector, Normally Open, Needs 1K Pull up Resistor

6 Stepper Motor Phase A+
7 Stepper Motor Phase A-
8 Stepper Motor Phase B+
9 Stepper Motor Phase B-
Base Material Aluminum Alloy
Surface Treatment Black Anodized
Load Capacity 45 kg
Weight 1.7 kg

Typical Accuracy

Resolution 0.001 degrees = 3.6 arcsec (10 Micro-steps per Step Motor Driver in use) 
Repeatability 0.05 degrees
Maximum Speed with Stepper Motor 12 degrees per second
Maximum Speed with Servo Motor 45 degrees per second 
Positional Accuracy 0.05 degrees
Repeatability +/-0.01 degrees
   
   


Mechanical Drawing

Mechanical Drawing of Hollow Core Motorized Horizontal Rotation Stage, Stage Diameter: 3.937 in (100 mm) 

 Ordering Information

Part No. Description Amount
AY110-100-01 Stepper Motor Driven Hollow Core Rotary Stage, Stage Diameter:100 mm, Aperture Diameter: 30 mm Click to Get a Quote
AY110-100-02 Three Phase Brushless Servo Motor with Quadrature Incremental Optical Encoder Driven Hollow Core Rotary Stage, Stage Diameter:100 mm, Aperture Diameter: 30 mm Click to Get a Quote

Related Products
Motion Controllers
Sharing link:


 

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us